• RUS
  • ENG

Resetting NBLC-2230V-SD and NBLC-2430V-SD cameras

Last update: 23.03.2023

1. Turn the camera’s power off;

2. Unscrew three hex head screws and lift the upper part of the dome off the camera:


3. Take out the SD card from the SD card slot of the camera (if used). In case you perform a reset with a card inserted in the camera, it will be formatted;

4. Plug the camera back into the power supply and wait for the camera’s system to boot (approx. 30 seconds);

5. Press down the Reset button (location shown in photo, next to the SD card slot) and hold it for 15 seconds:


6. Release the Reset button and wait for the camera to reboot (approx. 30 seconds);

7. Unplug the camera from power, install the SD card back into the camera (if used) and plug the camera back into power.

Was this article helpful?